Efergy Additional Sensor
Additonal sensors can easily be plugged into any spare socket of the three available on the Efergy transmitter.
The Efergy Elite and Efergy 2 Elink are both supplied with one standard clip on sensor which is all that is needed for a single phase supply (nearly all domestic supplies are single phase).
One additional sensor is required for a 2 phase or economy seven installation.
Two additional sensors are required for a 3 phase installation.
These standard additional sensors are suitable for cable with an insulated outer diameter of up to 13mm (use on cables smaller than 13mm diameter is fine). If your require sensors for cables with a larger insulated outside diameter order Extra Large Efergy Sensors .
The same sensors are used by the Efergy Elite and Efergy 2 Elink. These have a MALE "earphone plug" type plug fitting and may vary in colour from the picture above.
The old model - the original Efergy Smart Meter uses a slightly different FEMALE plug on it's sensor. Click on the small image at top of page showing for help identifying your sensor plug type.
Please indicate which model you will be using your additional sensor(s) with when ordering using the drop down box above.
There is no additional delivery charge if one or two additional sensors are ordered along with an Efergy Smart Meter. The delivery charge for a stand alone order for up to 7 additional sensors is £2.95 (incl VAT).
Write a reviewYour Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: