10W Solar Battery Charger with Charge Controller

10W Solar Battery Charger with Charge Controller
10W Solar Battery Charger with Charge Controller 10W Solar Battery Charger with Charge Controller 10W Solar Battery Charger with Charge Controller 10W Solar Battery Charger with Charge Controller 10W Solar Battery Charger with Charge Controller
Product Code: SC10CC
Availability: In Stock
Price: £99.95
Ex-VAT: £83.29

Available Options

* Cable Length:

Qty:     - OR -   Add to Wish List
Add to Compare

This powerful 10W solar charger is perfect for maintenance charging of 12V vehicle batteries which are stored over winter, used infrequently or suffer from discharged battery due to constant electrical drain from the battery (by an alarm for example). The powerful 10W panel means it can also be used in partially-shaded areas where other solar chargers would be inadequate.

  • Never suffer the disappointment of discovering you have a flat battery again!
  • 10W aluminium framed, glass fronted solar panel
  • Integral solar charger controller to protect against battery damage through overcharging 
  • Can be used anywhere there is sunshine - no mains electricity required
  • Can be used with all types of 12V vehicle / leisure battery (wet lead acid, AGM and gel)
  • Quick and easy to install
  • Quick and easy to connect/disconnect

Safe for your battery!

The beauty of this 12V solar charger is that it comes with a pre-installed charge controller (regulator) that eliminates any risk of damaging your battery through overcharging. This means that you can have a larger, more powerful 10W solar panel, that will be adequate for winter maintenance charging of 12V batteries up to 100Ah capacity, and that you can leave it connected to your battery all of the time, even through mid summer without fear of overcharging your battery. Many small 12V solar chargers do not incorporate a charge controller and as a result have a lower wattage solar panel that may not be adequate to meet your maintenance charging requirements. The inclusion of the charge controller allows you to simply connect up and forget until you next come to use your vehicle.

12V Solar Charger for Car, Boat, Van, Caravan, Campervan Battery

The larger 10W panel is useful if you cannot position the solar charger in an ideal un-shaded, south facing position. If the panel is approximately 50% shaded (so facing due east or west for example, or shaded by trees or buildings for half the day) it will still be adequate to provide winter maintenance charging of 12V batteries up to 50Ah capacity. Smaller solar chargers are likely to be underpowered when positioned in a less than perfect position.

12V Solar Charger Kit Contents

The charger comes fully assembled with everything required for quick and simple DIY installation.  

  • 1 x 10W solar panel with 3.5m cable (or optional 7.5m cable) with SAE plug for quick and easy connection/disconnection of solar panel 
  • 1 x Solar charge controller bonded to the back of solar panel
  • 2 x 100mm "Z" Mounts for permanent solar panel mounting
  • Battery connection lead with 8mm ring terminals and SAE plug (with weatherproof cover so can be permanently installed on your battery) 
  • Crocodile clip connection lead with SAE plug 
  • Simple cable tie fixings for temporary installation of solar panel

The solar panel and charge controller are fully weatherproof and can be permanently mounted outdoors even in exposed locations.

You just need to connect the lead to your motorcycle battery and install/position the solar panel. The solar panel can be screwed or bolted to any flat surface (4 screws and plugs are supplied but you must ascertain suitability of fixing method according to mounting surface and location) or temporarily fixed in position with the cable ties supplied.

Solar Panel Mounting

The kit is supplied with a pair of "Z" mounts to be attached to the frame using the bolts supplied. We recommend using Z mounts if you are mounting to a flat surface such as a wall as the regulator protrudes beyond the back of the solar panel frame by 19mm (see dimensions below).

Please note that we assemble these kits ourselves using quality components and offer full technical help and back-up. We are always happy to customise kits according to customers needs so please get in touch if you have specific requirements.


Solar Panel & Regulator dimensions 397mm L x 280mm W x  44mm D 

Please note that the Regulator protrudes beyond the back of the solar panel frame by 19mm. If mounting on a flat surface we recommend using "Z" mounts which hold the solar panel frame off the mounting surface by approx 25mm.

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:

Willgen, Church Farm, Wartnaby, Melton Mowbray, Leicestershire, LE14 3HU
VAT Number 350339081
Site By FCS Websites
Powered by Green Web Hosting
Feeds: Product | Sitemap | RSS